Get the app

Free tools

Printable ring sizer

Print this sheet at actual size, check it against a bank card, then lay a ring that already fits over the circles to read off the size in US and UK systems.

On this page
  1. How to print it correctly
  2. How to read your size
  3. Measuring a finger instead of a ring
  4. Try the size on screen in Ring Studio
  5. Why printed sizers go wrong

Loading the sizer… If nothing appears, check that JavaScript is turned on.

How to print it correctly

  1. Press Print the ring sizer above (or your browser's print command).
  2. In the print dialog, set the scale to 100% or Actual size. Turn off "Fit to page" or "Shrink to fit".
  3. Print on plain A4 or US Letter paper.
  4. Check the printout: a bank card laid on the card outline should match its width of 85.6 mm exactly, and the ruler should match a real ruler.

If the card doesn't line up, your printer has scaled the page. Adjust the scale setting and print again; even a 3% shrink is enough to give the wrong size.

How to read your size

Take a ring that already fits the finger the new ring is for. Place it flat over the circles and find the one whose outline sits exactly along the inside edge of the ring, not the outside. Each circle is labelled with its US and UK size; use the ring size converter for EU, Japanese, Indian or Swiss sizes.

Measuring a finger instead of a ring

The circles are for existing rings. To size a finger, wrap a thin strip of paper around the base of the finger, mark where it overlaps, and measure the length in millimetres. That's the circumference, which you can convert with the converter. Our step-by-step guide to measuring ring size covers the common mistakes, and this guide covers measuring for a surprise proposal.

Try the size on screen in Ring Studio

Once you know the size, Ring Studio can show how your ring design looks on a hand. You can also scan your hand in the app, with a bank card for scale, to get a size estimate to compare with your printout.

Why printed sizers go wrong

Almost every bad result comes from printer scaling. The second most common mistake is reading the outer edge of the ring rather than the inner edge, which can add a full size or more on a thick band. Finally, fingers change size with temperature and time of day, so a measurement on a cold morning may be half a size small. When in doubt, visit a jeweller: most will size you for free.

Frequently asked questions

How do I make sure the printable ring sizer is accurate?

Print at 100% or Actual size, with any Fit to page option turned off. Then lay a standard bank card over the card outline: it should match the 85.6 mm width exactly. If it doesn't, the sizes will be off.

How do I use a printable ring sizer?

Place a ring that fits the right finger on the circles and find the circle that matches the inside edge of the ring exactly. If it falls between two circles, choose the larger.

Can I measure my finger with the printable sizer?

The circles measure an existing ring. To measure a finger, use the paper strip method in our guide to measuring ring size, then convert the circumference with the ring size converter.

Is a printable ring sizer as good as a jeweller?

It's good enough to get close, usually within half a size, if printed correctly. For an expensive ring, confirm the size with a jeweller's ring gauge.

Design your ring in 3DGet the free app